When using each new Liquid Facelift Wand: With the cap on, hold the wand upside-down and gently tap the button with the palm of your hand 2-3 times. Twist the dispensing button at the bottom of the wand to the ON position. Remove the cap, place one finger over the applicator opening, and gently pump the button 3-5 times until the product reaches the opening on the antimicrobial applicator.

After the first use, the product will dispense with each pump, releasing a measured dose of the product; when necessary, administer a second pump.

Apply to clean, dry skin in the morning and at bedtime.

Using medium pressure, glide the applicator in an upwards motion starting on the chin, then along the jawline and continuing along the nasolabial folds and above the upper lip.

Continuing in an upwards direction, apply to the cheekbones and along the temples and, finally, in an upwards motion across the forehead. If desired, for an extra ‘lift’ repeat the application.

Secure the cap after each use and turn the dispensing button at the bottom of the wand to the OFF position.

How to Replace Refill Cartridge

Move the dispensing button at the bottom of the Wand to the ON position. Once in place, gently pull on the button to release the cartridge. Remove the cap from the refill and insert it into the body of the unit, turning clockwise to the OFF position.

For sustainability, as well as to enhance the results of our active ingredients, please use the refill cartridge until the wand no longer has the Liquid Facelift Wand serum. After a maximum of sixty days, it is important to have a new application device given the anti-microbial application as well as the airless component of each of the SBLA Sculpting Wands.

Store at room temperature and avoid direct sunlight.

Avoid using this product on the eye area; we recommend using the SBLA® Eye Lift Wand to lift the delicate skin around the eyes.

For best results, avoid using other skincare/makeup products for at least 15 minutes after application.

This product is meant for external use; if the product gets into the eye(s), rinse well with cool water.

**Individual results may vary.

General:
Use on clean, dry skin in the morning and at bedtime.
Pump the wand once to dispense the product on the antimicrobial roller ball applicator.
Using medium pressure, glide the rollerball applicator around the entire eye area, including upper eyelids, lifting up to and along the brow bone, under-eye area, and crows feet.
If desired, apply a second pump once the first application has dried.
Avoid using other eye creams or serums with this product for ten minutes.

For sensitive skin:
Only use on clean, dry skin.
A hot bath or shower will open up the pores of the skin so wait thirty minutes before applying product.
Use once daily in the morning.
Use one pump of product for both eyes.
Do not sleep with product on eyelids.
Note: If product gets into eyes, rinse out thoroughly with lukewarm water.

*Individual Results Will Vary

Start with clean and dry lips for the best results.

Apply to the outline of the lips following the natural lip line, including the cupid’s bow.

Apply liberally to the surface of the lips.

For enhanced plump use the wand to apply in an upwards motion on the upper lip and downwards motion on the lower lip.

Wait 5 minutes, then reapply if needed.

The Double The Plump - Lip Plump & Sculpt can use used daily and applied as often as desired.

Note: You may feel a warm or mild tingling sensation when applying the product. This is totally normal and will subside within a few minutes. Do not apply on broken skin or overly chapped lips.

*Individual Results Will Vary